ANTIQUE FURNITURE RESTORATION DISCUSSION BOARD

Re: Antique Piano Stool Hardware

Posted By: James Schooley <furnitureissues@earthlink.net> (0-1pool246-172.nas2.sioux-city1.ia.us.da.qwest.net)
Date: 2/27/5 18:49

In Response To: Re: Antique Piano Stool Hardware (carlene dahlman)

Van Dyke's.com has a modern version of this device, but the original would be best for antique value, even repaired. You can't weld cast iron, which is what you most likely have there. But an expert may be able to braze it tigether again. The original fit into the chair base with a lot of pressure and a couple of screws in the top flange. I think that it should go back in fine with longer screws and some wraps of masking tape to close the gap around the female shaft.

Messages in This Thread

• Antique Piano Stool Hardware
  Ellen Hatcher (host-216-78-120-31.sav.bellsouth.net) -- 7/7/2 21:54
  • Re: Antique Piano Stool Hardware
    bobup (12-216-236-41.client.mchsi.com) -- 7/7/2 21:59
    • Re: Antique Piano Stool Hardware
      Jim Cole (64-40-66-73.dialup.mebtel.net) -- 7/8/2 07:53
      • Re: Antique Piano Stool Hardware
        Jim Schooley (pmspen1-99.rconnect.com) -- 7/8/2 23:01
        • Re: Antique Piano Stool Hardware
          frank jarka (ppp-32-22.mtl.aei.ca) -- 4/16/3 15:18
        • Re: Antique Piano Stool Hardware
          L & R Irish (cpe-24-195-87-192.nycap.res.rr.com) -- 2/27/5 15:56
      • Re: Antique Piano Stool Hardware
        carlene dahlman (116.portland-01-03rs.or.dial-access.att.net) -- 11/8/3 13:48
        • Re: Antique Piano Stool Hardware
          James Schooley (0-1pool246-172.nas2.sioux-city1.ia.us.da.qwest.net) -- 2/27/5 18:49

ANTIQUE FURNITURE RESTORATION DISCUSSION BOARD is maintained by Administrator with WebBBS 3.21.