ANTIQUE FURNITURE RESTORATION DISCUSSION BOARD

Re: Hardware for cabinet

Posted By: James Schooley <furnitureissues@earthlink.net> (0-1pool247-148.nas2.sioux-city1.ia.us.da.qwest.net)
Date: 6/23/5 01:58

In Response To: Re: Hardware for cabinet (Greg Scholl)

Be warned, as to Greg's suggestion on drilling out the holes for a larger size, you could drill right through the sides. Use a small 3/4" x 3/4" block of wood to make a spacer so that the bit can only drill a 1/2" depth. Place some masking tape over the hole you intend to enlarge so that the block does not leave a circular spin mark on the old finish. Also try wrapping one of the shelf supports with a thin strip of paper and tape to make a tighter fit.

Messages in This Thread

• Hardware for cabinet
  Shanali Morgan (cpe-70-93-162-139.socal.res.rr.com) -- 6/21/5 17:45
  • Re: Hardware for cabinet
    Greg Scholl (67-22-200-210.albyny.adelphia.net) -- 6/21/5 21:42
    • Re: Hardware for cabinet
      James Schooley (0-1pool247-148.nas2.sioux-city1.ia.us.da.qwest.net) -- 6/23/5 01:58
      • Re: Hardware for cabinet
        Greg Scholl (0-1pool196-228.nas27.somerville1.ma.us.da.qwest.net) -- 6/23/5 22:37

ANTIQUE FURNITURE RESTORATION DISCUSSION BOARD is maintained by Administrator with WebBBS 3.21.